Aventura Technologies VENDOMA-MPG Guide d'installation télécharger pdf (Page 31)

VENDOM

2. For power connection, you may utilize one of the following 3 sources.

- 1 : Connect the power cable from power unit to socket No.2 (+5V)

- 2 : Connect the power cable from power unit to socket No.3

- 3 : Connect power cable from capture board to socket No.1(Option)

3. Set the jumper as follow, on RS-422 Pan/Tilt settings

Set the jumper as follows, on RS-485 Pan/Tilt settings.

4. Connect the cable from RS485/422 port to PTZ driver as displayed in the following figure.

5. If you use the PTZ supported with 232 Pan/tilt, connect the cable from the PTZ to PC serial

port directly.

*NOTE:

P/T/Z Cameras require 3 different wiring types.

A. Coax Cable (RG59/RG6) –For Video

B. Power Wire(1 Pair)-For AC 24/DC 12 Volt Power

C. 1 Pair Wire (Positive and negative wire)-For P/T/Z Controls

1 2 ... 26 27 28 29 30 31

Pas de commentaire

Aventura Technologies VENDOMA-MPG Guide d'installation Page 31